7point62fmj Posted February 10, 2006 Share Posted February 10, 2006 I am going to get my heads decked (and a few other things) for my brat.. I am thinking .025 or should I go .020? So how much did you pay or should I expect to pay. Quote Link to comment Share on other sites More sharing options...
shawnsbrat Posted February 10, 2006 Share Posted February 10, 2006 I am going to get my heads decked (and a few other things) for my brat.. I am thinking .025 or should I go .020?So how much did you pay or should I expect to pay. I suggest http://ramengines.com/ to do the machine work they speacialize in suburus.Email ron and he will give you a quick answer on anything you throw at him. Quote Link to comment Share on other sites More sharing options...
idosubaru Posted February 10, 2006 Share Posted February 10, 2006 $40 per head for milling. if you're talking complete valve job, pressure tested and milled, about $150. add $25 - $40 for any cracks between valves seats that may need repaired. i would consider these on the high end of prices since prices are higher around where i live. you can get a few bucks lower in more rural areas. Quote Link to comment Share on other sites More sharing options...
7point62fmj Posted February 10, 2006 Author Share Posted February 10, 2006 Thanks:banana: Oh one more thing my brat only has 60k on it (thanks Mic) do you really think I should get a valve job? Quote Link to comment Share on other sites More sharing options...
Ross Posted February 10, 2006 Share Posted February 10, 2006 You may as well get the valves/seats re faced since you've got the heads off. I very much doubt you'll need new guides (best to check though), so just do the re facing and valve seals. Shouldn't cost much at all. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.