Jump to content
Ultimate Subaru Message Board

What is the Power Light on the dash


Recommended Posts

I'm not sure about this but I see your cars in an automatic. Do you have the 4spd automatic or the three speed? I believe the 4spds had a switch on the stick that you pressed for Power mode which let the engine rev higher before shifting. I know the Legacys with the 4spd auto had that, just not sure if the Loyale autos had that.

 

Keith

Link to comment
Share on other sites

Keith is real close.

The "Power" light on the 4EAT serves two purposes.

1) As Keith alludes to, it indicates the transmission is in a special mode

where it holds each gear to a higher RPM than normal.

This mode is invoked by the speed at which the throttle is depressed.

Stab the loud pedal quickly and the power light should light.

Hold the pedal down and the shift RPM will be increased

(I believe it also increases the hydraulic line pressure in the transmission shift circuits)

 

2) The "Power" light also serves as a check for the operating components of the electronic controls.

If the TCU (Transmission Control Unit) detects a problem with one of these controls,

it will flash the light upon start up. The TCU can be put into a mode where it will flash the light to indicate the trouble.

 

 

The "Turbo" light illuminates any time the intake manifold is at a positive pressure.

(It also indicates the ECU is in the run rich mode, ignoring the 02

sensor and adding fuel to cool the combustion process.

Hope this helps

Link to comment
Share on other sites

yes thanks, the power light comes on at certain times on hard acceration. the car is a 4 spd auto.

 

I have another question. When i accelerate out of corner, the inside front wheel starts to spin and then there is a big jerk and the car feels more solid. Is something happening in the rear drive line as well?

Link to comment
Share on other sites

The car is only in two wheel drive (one actually -open center diff) until the TCU sees the front set spinning faster than the back, it then drops the signal to the rear clutch pack drain duty solenoid and thus engages the rear drive.

I believe this is what you are feeling

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...