adema2626 Posted June 7, 2010 Share Posted June 7, 2010 Here's the deal, my clutch started slipping, so I pulled the motor and installed a new clutch. Had some difficulty getting the splines to line up correctly on the motor and finally got it. I tried just turning the motor over with a wrench and couldn't do it and thought this was weird at the time(the tranny was out of gear.) I got everything back together and installed. I go to turn it over and it turns over and starts up for a few seconds, but it didn't last long because there was no fuel left in the system and it was still sucking it through. Was able to do this a few times and all the sudden it just stopped and would make a thud/clunk noise. I've had this happen a few times and I was thinking it was possibly a bad connection to the starter. I clean everything and tried it again, same deal. I tried jumping the power straight to the start as well and it did the same thing. I also tried turning the crank over by hand at this point again and it still wont turn freely even when out of gear. I'm 99.99% sure I installed the clutch correctly, this is not the first one I have done. Any ideas or suggestions would be great. I really don't wanna pull the motor out again even though it only takes an 45 minutes. Quote Link to comment Share on other sites More sharing options...
adema2626 Posted June 8, 2010 Author Share Posted June 8, 2010 Anyone??? Any suggestions at all? I really don't wanna pull the motor if I don't have to. Any other ideas on what it could be? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.