Jump to content
Ultimate Subaru Message Board

I got my hydraulic lifters apart ... kinda


Recommended Posts

http://falenseraf.lardpirates.com/DSCF0003.JPG

Here you can see what I got them down too.

http://homepage.powerup.com.au/~camncath/ea82_hydraulic_lifter_fix.htm#O-ring

And here you can see what I need to get them down to

 

But how do I get the springs out to get to the bad oil below. I can see them and compress them but they don't come out and I can't pull on them in anyway.

Link to comment
Share on other sites

i got them out using a combination of solvent, thin oil (MMO), and a lot of banging them on a countertop. You can also get a bit of air into the area on the other side by holding the lifter upside down and gently poking the ball in the center. It also helps to have the lifter upright and full of MMO and poke the ball to get that down there. You can sometimes get the plunger to move a bit by sticking your pinky finger down there and pulling on it.

Link to comment
Share on other sites

Thank you for your advice. After some banging and some curseing they came out. However now I am haveing trouble putting them back together. I will try again tomorow and see what I can do. Once I fill them with oil and put the spring and other thing in at a certain point it refuses to compress anymore. I am guessing this is because the oil in the bottom won't compress since well that is what oil does. Do I have to mess with the little ball to get some of it to come out and then keep pushing it down?

Link to comment
Share on other sites

Ah, you just got to the fun part. This took me an hour to figure out.

 

To get them back together, you will need a dull awl or similar tool that can press on the little ball, and a piece of hose a couple inches long that fits inside the main body of the lifter and can push down on the inner plunger thingy, while allowing the awl to freely move inside of it. And you need a flat screwdriver to apply downward pressure to the hose.

 

Now, once you have the spring and plunger/ball assembly thing inside the main body, which you have assembled under oil, set the lifter assembly in the oil, which should be at least an inch deep. To depress the inner lifter assembly, do as follows. Stick the awl through the hose first, then insert this into the lifter body. Use the awl to depress the little check ball so that oil can flow freely. Now use the screwdriver pushing on the hose to shove the entire assembly as far down into the lifter body as possible. Release the awl to shut off the check valve, then release the pressure on the hose. Without removing the lifter from the oil, put the other piece in. Then you can temporarily take it out to put on the retaining collar.

 

This probably sounds really weird, but it will make sense as you do it.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...