Jump to content
Ultimate Subaru Message Board

2wd no go, 4wd go


Recommended Posts

pop the hood

put in D or 1st gear and 2wd with park brake on

get out and see if axles are spinning.

if axles are spipnning, check the axle nut. if it's spinning, then hub is stripped (very little noise). if nut not spinning then CV is totally out and should make lots of noise).

if axles not spinning, then internal problem. replace trans.

Link to comment
Share on other sites

Check to see if it HAS any front axles. If one was removed, and the outer cup used to install the wheel, then you would get no sound. A broken axle should indeed make a lot of noise. Something like an impact wrench. The hub being stripped would initially make noise, but once ground up sufficiently, might quiet down a bit... should still be awful loose, and the wheel would wobble a bit I would think.

 

GD

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...