Jump to content
Ultimate Subaru Message Board

Factory setting for front end ride height


Recommended Posts

About once a year or so my front end eats an axle either by pulling the boot off the joint area or by tearing it.. So I took a look at it the other day and looks to be a pretty harsh angle on the axle. I am curious to know how high my 86 hatch should be off the ground and where it is measured from ( bottom of steering knuckle or from the oil pan etc.)

 

Mike

Link to comment
Share on other sites

Should be 10.6-11.6-inches with 185-70-13's properily inflated on level surface. This is measured to the center of the lower "A" arm through bolt. If in doubt i would drop it all the way down, I believe that is how they came from the factory. I had the same issues as you, eating up boots, suspenion was topped out. You should be able to easily tell that without removing tires, adjusting nuts are front and rear on the front struts.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...