biscuitb32 Posted March 19, 2004 Share Posted March 19, 2004 Hello, My 90 Sub Legacy Sedan was in a minor but major accident. I have all the replacement parts, two fenders and replacement bumber absorber and bumper cover. It was hit in the drivers side front end. Some people say that it can be pulled back out with the new fender to reference. My question is that the radiator support and the support that the hood lock is on is welded. If pulling dosen't work is there a way to replace that welded things or am I looking at a lot of work ect. I have all replacements which I suppose would mean unwelding from the other car. any advice would be appreciated. Thanks, Tim Quote Link to comment Share on other sites More sharing options...
calebz Posted March 19, 2004 Share Posted March 19, 2004 If the core support is bent beyond repair.. you will have to cut the straight one from your parts car and weld it in.. just make sure your frame rails aren't bent as well... Not worth fixing at that point.. unless you really have a special attachment to that car.. Quote Link to comment Share on other sites More sharing options...
edrach Posted March 19, 2004 Share Posted March 19, 2004 You might be in luck. There are currently two early Legacys at the Lynnwood Pull a Part with straight front ends. It would be a source of straight parts for you if you need them. Rent a portable sawsall and you're good to go. Quote Link to comment Share on other sites More sharing options...
Legacy777 Posted March 19, 2004 Share Posted March 19, 2004 yeah if the core support is bent beyond bending it back....you'll need to cut the old one out and weld a new one in. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.