Russell Posted March 23, 2004 Share Posted March 23, 2004 Hey guys, I am wondering if there is any truth to some information I ran across about rebuilt EA82's. It was some source that offered rebuilt engines, claiming that the material in these older engine blocks was too thin to rebore. Is honing ok? I would like to pick up a short block EA82 from ccr engines, heard they were the best and they have a 3 year 36,000 mile warranty but I don't want to get something that's not going to last. What is the USRM, and where is it? thanks in advance Russell Quote Link to comment Share on other sites More sharing options...
moosens Posted March 24, 2004 Share Posted March 24, 2004 Russell,click on the USRM up in the left corner of the most of the pages on this board.That's the Repair Manual...a work in progress. CCR is very reputable.Lots of folks here have dealt with them. Good luck. I'll be in Harrisburg May 21-23 for the Carlisle show.Join us if you get a Subaru or not. Quote Link to comment Share on other sites More sharing options...
Russell Posted March 24, 2004 Author Share Posted March 24, 2004 Thanks a lot. That's what I heard about ccr, its good to have it confimed Russell Quote Link to comment Share on other sites More sharing options...
bushbasher Posted March 24, 2004 Share Posted March 24, 2004 theres no problem with honing the block. By reboring you're going into dangerous territory according to some. Some say too thin, some say it will spin the sleeves in the alum. block. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.