Jump to content
Ultimate Subaru Message Board

what soob has 2 piston calipers


Recommended Posts

Found a legacy in the junkard around here (Not saying where ya vultures!) and it has one crossdrilled rotor on it ( the other is missing) but both sides up front still have the calipers, and they are two piston.

 

-> What are they off of? (The car they are on is a gen 1 legacy)

-> Will they fit my Turbowagon with its 5 lug conversion

-> If so, do I just need teh calipers or do I need anything else?

Link to comment
Share on other sites

The only first gen legacy 90-94 that had twin piston calipers up front was the turbo legacy.

 

Assuming you've swapped a standard legacy hub over, you should be good to use those calipers. You'll need at least 15" wheels to clear the calipers. You need the calipers and caliper brackets. The brake lines will be fine.....and you'll need new brake pads.

Link to comment
Share on other sites

yeah now that I think about it that car might be a turbo, I couldn't tell cuz the motor was gone as was teh hood and trunk lid. I don't have a legacy knuckle in my car, I'm still running the XT6 knuckle, but I think I will be going up and picking up the calipers and the one crossdrilled rotor for later use :-)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...