Jump to content
Ultimate Subaru Message Board

Complete Cone Washer Failure


 Share

Recommended Posts

The "flat washer" is a spring washer, it isn't flat.  The concave side goes against the cone washer.

 

To avoid the problems at the beginning of this very old thread, make sure the nut is tight.  Re check it a few drives later, also.

Link to comment
Share on other sites

Yes the domed side goes towards you, the newer ones are marked with "out" but I just picked up two sets of wheel hub hardware and the one nut was marked on the right side but the other said "out" on what was really supposed to be "in, so always just look for the convex and put it towards you

Link to comment
Share on other sites

  • 3 years later...

Hi, and welcome to the forum.  Holey zombie thread...  It would be a lot better to start a new thread, than post on the 3rd page of a 2 year old one...  But anyway,
The 84 may or may not.  I know first hand that 86-93 are interchangeable. 
 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...