Jump to content
Ultimate Subaru Message Board

loyale shifter linkage bushings


Recommended Posts

Fairly sure someone on here did a DIY shifter bushing fix for the EA82 5-speed trans using hardware store parts.

Didn't see it in the USRM, but it should've been there. Was pretty good fix.

Been roughly 1-1/2 to 2 years, I think

 

I was able to find some plastic bushings close to the same od as the shifter, I had to buy a metric drill bit to ream out the id just a little .. 1/2 inch od was very close , needed to sand it just a little and a 3/8 drill is is real close to the id . then I used a hacksaw to cut the bushing to 1 and 1/4 inch in length.

Edited by ivantruckman
spelling
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...