Way 2 go.....so far so good......time will tell. I bet you will be fine....The Green Hornet will keep buzzin
Welcome to Ultimate Subaru Message Board, my lurker friend!
|Welcome to Ultimate Subaru Message Board, an unparalleled Subaru community full of the greatest Subaru gurus and modders on the planet! We offer technical information and discussion about all things Subaru, the best and most popular all wheel drive vehicles ever created.
We offer all this information for free to everyone, even lurkers like you! All we ask in return is that you sign up and give back some of what you get out - without our awesome registered users none of this would be possible! Plus, you get way more great stuff as a member! Lurk to lose, participate to WIN*!
* The joy of participation and being generally awesome constitutes winning
** Not an actual guarantee, but seriously, you probably won't regret it!
Serving the Subaru Community since May 18th, 1998!
Green Hornet project.
Posted 09 July 2013 - 11:28 PM
Is that where MAP comes into play? Manifold Absolute Pressure?
Manifold Absolute Pressure is just a measurement of the difference in pressure between the intake manifold and atmospheric pressure.
It's really a useless number to us, but the ECU uses it to help determine air density and calcuculate air/fuel ratio adjustments.
Glad to hear its running well. Hopefully it will stay that way.
Posted 10 July 2013 - 10:08 AM
Edited by darsdoug, 10 July 2013 - 10:35 AM.
Posted 10 July 2013 - 12:45 PM
The question of interference with phase 2 heads on a phase1 2.2 block has come up a few times and as far as I know there hasn't been any solid evidence that it is not interference. The pistons in that block have reliefs for the valves, but the reliefs were designed for the valves in the phase1 heads. The phase2 2.2 heads increased valve angle from 15 to... I wanna say 20 or 22 degrees. Which makes it so the head can be shorter (overall height off of the deck) but it also increases the depth (down into the cylinder) of the edge of the valve when its open.
I would just assume it to be interference just to be on the safe side. Unless you want to pull the heads and clay the pistons to determine valve height above the piston.
Edited by Fairtax4me, 10 July 2013 - 12:59 PM.
Posted 11 July 2013 - 09:27 AM
Hmmm?..... So any valve float whatsoever at high RPM would be a bummer?
Posted 11 July 2013 - 10:19 AM
Posted 23 October 2013 - 10:41 PM
Look what I found in the glovebox today.
Posted 20 December 2013 - 02:59 PM
Update: Well.... I have put over five thousand miles on the engine since last summer with no problems whatsoever. It's still running pristine.
Posted 19 July 2014 - 09:12 AM
Update: Now over ten thousand freeway miles going back and forth to work since last summer and still running fine.
Considering how much torque/pressure I applied to all four corners of that one cylinder head (for about five minutes or so) I honestly believe I should take it off and check for distortion/flatness of the head and purchase another gasket. Although I'm tempted to just go with it and hope for the best. I know I put a generous amount of copper spray on the gaskets beforehand. If only I could remember whether it was the left or the right side of the engine? Yup. I might just go with it. I wonder what kind of odds Las Vegas will give it.?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users