A driver at jimmy john's (which is becoming a subaru club in its own rite) had issues with no-starts from warm. The car would start with throttle, but stalls at stops.
I suggested replacing the engine temp sensor, which i installed. This cured the fail-to-start condition, but now the temp gauge on the dash maxes to H and the fans are on from cold.
This is a 3 pin sensor with no other sensor for the gauge. The sensor appeared correct; the plug was a little tight to fit on.
I am wondering if i have a pinout incompatibility, Do i have the wrong part? This is the echlin brand from napa for some $22.50