Welcome to Ultimate Subaru Message Board, my lurker friend!
|Welcome to Ultimate Subaru Message Board, an unparalleled Subaru community full of the greatest Subaru gurus and modders on the planet! We offer technical information and discussion about all things Subaru, the best and most popular all wheel drive vehicles ever created.
We offer all this information for free to everyone, even lurkers like you! All we ask in return is that you sign up and give back some of what you get out - without our awesome registered users none of this would be possible! Plus, you get way more great stuff as a member! Lurk to lose, participate to WIN*!
* The joy of participation and being generally awesome constitutes winning
** Not an actual guarantee, but seriously, you probably won't regret it!
Serving the Subaru Community since May 18th, 1998!
Cyclops Install Help
Posted 03 March 2014 - 02:35 AM
Couldn't find any clear instructions.
Thanks in advance
Posted 03 March 2014 - 09:06 PM
i too am curious. i have a 3rd eye light for my brat and will need to figure it out when the time comes.
Posted 03 March 2014 - 10:25 PM
Someone may have clearer instructions, (such as http://www.ultimates...how-is-it-done/)
but you need a always-on hot for supplying the relay circuit, and switched power for the lamp switch. This way when you turn the car off the light goes off and the door closes. Or you can wire it to stay on without the key, just run the switch to hot, and hope the battery stays good if you forget. I wired it to key switch because I forget.
Main tricky parts
is cutting out the welded radiator support, at the front. not to worry, that lamp bracket is more substantial than what you're removing. I removed just enough, and then part two:
Cutting the newer grille (in my case) to fit the cyclops door. You'll have to get everything locked down grille-wise to make sure the door clears the grille smoothly.
Interior: Drill out blank circle. May be easier to remove and drill, but otherwise, put the hole in, put the switch in behind it...
Be careful, one car I pulled wires from seemed to have had damage from a failed lamp switch. It breaks apart, leaving all those nice bare leads right in the middle of metal brackets. I gave mine a wrap in electrical tape just to be sure.
Also, there's a couple of levels of bulb brightness you can get. I went for the lower wattage because I have 4 other headlamps and was concerned about heat.
Posted 04 March 2014 - 02:50 AM
I got the grill and radiator support covered... it's the electrical that is definitely the challenge. Question for you... where does the Red (blue) wire from the switch and the Red (green) from the timer/box go too? I didn't see them on the diagram you linked to.
Thanks for your help,
Posted 05 March 2014 - 08:22 PM
Posted 25 May 2015 - 11:59 PM
I know this is a old thread but did you ever get the third light sorted out?
If so where did you end up hooking the wires from the switch to?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users