Jump to content
Ultimate Subaru Message Board

Looking for engine and tranny xmember spacer from an outback


Recommended Posts

I haven't had much luck in any other forums so I figured I would try here. I would like to buy the 1.1/4" spacers from the engine and transmission crossmembers on a 95-99 outback. I will pay to have someone take them off a parts car or wrecker.

Link to comment
Share on other sites

Spacers on the trans cross member are welded on so you need the whole thing, plus bolts.

 

You will also need the transverse bushings for the front control arms.

 

No they aren't.  the paint sticks them toghether.

 

they wack off with a hammer.

 

You don't need the LCA's with EA lift.  that's if lifting form Leg/Imp to FOR/OBK stuff.

Edited by Gloyale
Link to comment
Share on other sites

The last ones I saw definitely had a couple tack welds. Maybe that was someone's approach to make them stay put during removal/install of the crossmember.

 

I wasnt aware the OB cross member spacers were commonly used with EA lifts.

 

Hockey pucks are cheap and easy to drill through.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...