Jump to content
Ultimate Subaru Message Board

mystery item pic :)


jono
 Share

Recommended Posts

they aren't mystery to me, maybe to others though

 

DSC06408_zpsa87fce30.jpg

 

and an Australian $2 coin does not help many get an accurate idea of the dimensions of the black things.

 

Going in an EA81 body. Complete set, just knocked them up from over engineered spec 5mm plate/bar , just not finished - need a hole in each to do that.

 

Anyone time to waste to guess ?

Link to comment
Share on other sites

OK, fingers off the buzzers !

 

I hope it did not hurt too many heads :) Tom has got it 

 

I plan to shove EA82 front struts in EA81 to make use of some left overs, do away with old soft struts, and the three stud strut mounts are needed to take the larger bore strut. The jelly bean shape was taken directly from the factory reinforcement plates fitted to the tower tops. Going to need two per side for the new hole locations.

 

WooHoo Tom, well done !

I have a crusty old mount I have removed the splined studs from. Going to drill one of three mount holes out to suit the EA81 M10, mount the old crusty underneath where they belong, use an M10 to bolt it in, as a template drill guide at the front side. Using the rear most hole as the single to keep the strut line-up in 4WD position. It will look mounted in reverse to EA82 strut tops.

This whole idea will also help towards in keeping suspension from donor vehicle to go with donor engine - EA82T :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...