Jump to content
Ultimate Subaru Message Board

Video: Hunting throttle during OEM coolant burp procedure


Recommended Posts

After replacing my radiator I started with a distilled water/white vinegar mix, then three rounds of water flushes. On the water flushes I used the factory-preferred method and had some pretty interesting results.

Before I explain what happened, let me tell you what did NOT happen:
  • The engine did not overheat.  The temp gauge didn't budge above normal at all after reaching operating temperature. I attribute this to massaging the radiator hoses a whole bunch before capping the system each time.
  • The check engine lamp never came on. As in, not once. Not even a flicker.
  • I did not change throttle position at all when the phenomena began, until noted in the video.
  • It was repeatable enough to happen on three consecutive "burps."


So, what did happen? About 6 or 7 minutes into my 10 minute burp procedure, I would lose control of the throttle. Mind you, this is a drive-by-cable throttle, and I hadn't changed the throttle position at all.

When this happened the rpms would drop down to about 1,250, then up to 1,750 rpm and repeat until I either floored the throttle, or backed out and let the engine idle.
 



What the hell is going on?

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...