Jump to content
Ultimate Subaru Message Board

Gauge cluster swap question;


Recommended Posts

I would like to swap the full gauge cluster (oil pressure, voltmeter, etc) from my 87 GL into my 93 Loyale. I'm wondering if the appropriate connections are still there in the dash for the additional gauges or if I'll have to run my own lines/grab certain plugs from the GL.

 

I'm also curious of the speedometer will be accurate going from a 5 speed dual range car into a 5 speed front wheel drive car. Is 5spd fwd 3.9 final drive?

Link to comment
Share on other sites

I did this for my 93 Loyale.  It had only idiot light for oil and no voltmeter.  All of my earlier Loyales and GLs had all meters.   you need to get the oil pressure sender for the engine, and move the wire from the switch sender.  The same wire works for the signal.  The voltmeter is just wired into the circuitry, so it will just work.

  • Like 2
Link to comment
Share on other sites

Any suggestions on running the old GL odometer *up* to match the loyale? I took it apart to see how easy or hard it would be to just swap the odometer assemblies, but it does not look like something simple.

I could run it on a drill but that will probably take a week, I have to advance it some 13,xxx miles....=\

Naturally I could just throw it in as is, but if there's a way, I'd like to do so.

Link to comment
Share on other sites

Yes, a drill will take forever. A Dremel however, will not. Huge RPM difference. Depending on the Dremel speed, 13K should only take 5 or 6 hours I would think. Done it before, but now I just crack them open and change them. It's a bit of work, but faster than the alternatives.

Link to comment
Share on other sites

I will check out the dremel I have at work. Didn't think of that. It does spin pretty fast.

I had the circuit board off on the speedo side and the plastic cover off the front. I couldn't even manage to get the speedo needle off, though I didn't spend *too* much time looking. Maybe it's held in with a roll pin? Either way I put it all back together and gave up on the idea of taking it apart. I'll just run it up with something. 13k at 130mph shouldn't take too long, if the dremel spins fast enough to get the needle up around there.

Link to comment
Share on other sites

When I swapped mine, I swapped the speedometer. The black center plastic cap pulls off. There is a nut under it. Not sure why I bothered, it has a different engine and transmission in it now anyway. The miles are on the body, and wheel bearings. Resale won't likely be a problem, I've never sold one of these cars. Except vary rusted out bodies to a scrap metal dealer. ...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...