Jump to content
Ultimate Subaru Message Board

Recommended Posts

1995 Subaru Legacy L Wagon - MT / EJ22 / 186K

 

So pulled the clutch today and found a suprise...attached.   I now know what that noise was.

 

I am thinking that the throwout bearing caused the damage.   The throwout bearing looks good.   But was missing a clutch sleeve clip / spring release clip / weight release lever as show in the diagram.  It was super loose front to back / side to side when I pulled it.

 

Plan to replace bearing / clips / springs / fork (has a stress crack).

 

Just want to make sure I have covered all the bases.

 

Thanks again!

 

Tom

 

 

post-59509-0-70303400-1440462000_thumb.jpg

Edited by mcnea001
Link to comment
Share on other sites

That happened to my friends honda as well. Spring broke out of its holder and jammed against the flywheel. New clutch kit and you'll be good to go.

Be sure to replace those paper clip looking clips that hold the release bearing to the clutch fork.

 

The clutch forks also have problems with the pivot point wearing and eventually the fork cracks, then the clutch doesn't release. If there is excessive wear in the cup where it pivots replace the fork also. About $40 for the fork and all the clips from a dealer. Don't forget the big Y clip.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...