Jump to content
Ultimate Subaru Message Board

How do I adjust my clutch. Is that the problem?


Recommended Posts

There should be an adjustment at the clutch fork under the hood. If its a cable that is, I'm not sure of that year. If it is hydrolic there is no adjustment it probably needs to be bleed. If you aren't getting disengagement of the clutch a few inches above the floor adjustment is probably neccissary. I would start saving up for a new clutch though you are probably getting close to the end of the clutch life if your pedals that low.

Link to comment
Share on other sites

As the clutch wears the release point moves higher

Somebody probably adjusted it close to the floor because they liked it that way.

Clutch release lever sticks out the top of the trans on the drivers side. Clutch cable is on top. Should be a 12mm adjusting nut and a 10mm lock nut. Adjust free play of the release lever to about 1/4".

It should have a hill holder which is the smaller cable beneath the clutch cable. After adjusting the clutch cable, adjust the holder cable until it just barely starts to pull the lever on the holder mechanism.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...