Jump to content
Ultimate Subaru Message Board

Are these the wrong bearings (85 Brat?)


Recommended Posts

Got a set (supposedly inner and outer) of rear wheel bearings for Bratula, and they don't match. One is much larger than the other...my Haynes manual shows both one piece and two piece styles - but they seem to match eyeball wise. Do Brats have a flat roller bearing and then a conical one for the rear ends?

 

Thans

Scott

Link to comment
Share on other sites

Rear wheel bearings for all EA81 and EA82 4WD vehicles are either a single sealed unit containing two roller bearings and races and a spacer , or a three peice affair with a single race, and two roller bearings that fit in either end of that race. In both cases the two taper bearings are the same size. Under no circumstances should either of those bearings be a non-taper bearing. The front wheel bearings use two flat ball bearings on each side.....

 

This is a rear wheel bearing *assembly* (1 per side):

 

513056.jpg

 

This is a front wheel bearing (2 per side):

 

K800027799.JPG

 

The only thing I know of that uses different sized bearings is the rear bearings on a 2WD - they are loose taper bearings and one is larger than the other.

 

GD

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...