Jump to content
Ultimate Subaru Message Board

Disk Brake Tool


Recommended Posts

I just use a pair of pliers or vise grips or something. If the piston is really tight/stuck you have other problems. Undo the bleeder screw so you're just pushing fluid out the caliper, not back into the system. Should make things easier.

  • Like 2
Link to comment
Share on other sites

I just use a grinder wrench that has 2 pins. It works pretty good considering you don't have to change brakes very often. If i want to get fancy i could cut off the head and weld a socket to it to make it go faster with a ratchet. At harbor freight they have a little cube that does the same thing for a 3/8 ratchet not sure if it will work on these or not but they're less than $10.

Edited by turbosubarubrat
  • Like 1
Link to comment
Share on other sites

I recently bought a cube from Knechts Auto Parts but I haven't tried it yet. I have used those in the past. Then there was the elongated version that had the two pokies (spanner) on one end and a hex the other end, difficult to handle while slipping off frequently.

Thanks all from Larry G. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...