Jump to content
Ultimate Subaru Message Board

EA82 crank pulley modifications (timing marks)?


Recommended Posts

So a mate's mum crashed her spider manifold EA82T Vortex (XT).

 

I've put the engine into my wagon, but got some problems because the XT didn't have aircon. This means it also has the wrong alternator. And impossible to get the correct ones where I am.

I'm also adding a water-air intercooler from a 1st Gen Legacy, so the timing marks on the flywheel are impossible to see.

 

Because of wrong accessories, I've changed all the pulleys over to V belt, but this means I've lost the timing marks on the crank pulley. I will definitely need these as my mate made the engine previously run off a Series 1 "Black" ECU and changed the distributor. Mine's a Series 2, so I need to put the proper distributor back in.

 

Trying to figure how to accurately put them onto the carb pulley, along with drilling a locating dowel hole (which I will do first).

 

any help appreciated

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...