Jump to content
Ultimate Subaru Message Board

Brake light on during cold weather.


Recommended Posts

My '03 Legacy GT sedan has it brake dash light come on whenever the temp is below 30 degrees. Brake fluid is clear, and in between the max and min Mark. Brakes well, no ABS light. It goes out after 7 min of driving. Sometimes comes back on if hard braking.

Link to comment
Share on other sites

That light is connected to a switch on the ebrake lever, and a level switch in the reservoir. Usually it just means slightly low fluid level. But the switch can be faulty.

 

If the fluid is definitely full, unplug the switch on the reservoir. If the light no longer comes on, it's that switch....

 

Switch alone is part #26456AC000, It is discontinued from Subaru, and no dealer in the US shows inventory. However, it looks like you can get one straight from Japan through Amayama: https://www.amayama.com/en/search?q=26456AC000

Link to comment
Share on other sites

I'd expect the light would be on solid if you disconnected the float switch - but I'm not 'certain'.

 

most systems are made 'normally closed' so a break in wiring will 'announce itself' .

 

if you splash in even a just a tablespoon of brake fluid - it may make enough difference that the light stays off - if not, then investigate eslewhere.

 

also, what happens to your DRLs when the light is on? parking brake turns them off but low fluid wouldn't.

Edited by 1 Lucky Texan
Link to comment
Share on other sites

The low fluid switch is definitely normally open. Unplugging it will disable it.

 

 

I know on one of the Subarus I had, low fluid disabled the DRLs. Don't remember which one. Although a quick look at my '04 diagrams, it's definitely the same wire from the parking brake switch, both just switched-to-ground and there's no diode, so I'm not sure how the DRL module would have any way of knowing which switch was activated.

  • Like 1
Link to comment
Share on other sites

shortlid,

 

I agree with Numbchux and brus brother. One of my past OutBacks had the same issue when it was extremely cold. It drove me crazy until I added brake fluid to the master cylinder to bring the level up to the Max line. Want things to expand ... add heat. Add cold ... things contract, just like the brake fluid volume in the reservoir. It shouldn't be that touchy at mid way between add and max, but it is a 14 year old car and deserves its character flaws.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...