RAW Posted February 3, 2017 Share Posted February 3, 2017 Get the Factory Service manual for your year engine. That will have all of the specs needed or checking the valves and seats. The biggest thing you're looking for is that the seat and the valve face have flat surfaces where they seal. If the seat is worn to a point or there is a groove in the valve then the seat need to be recut and the valve replaced. Lapping is generally only necessary when replacing a valve. If the valves all have nice flat sealing surfaces then I would not bother with replacing any. You will need to set the lash clearance after reinstalling the valves, and then you'll need to check it again after running the engine for a few weeks. Quote Link to comment Share on other sites More sharing options...
ocei77 Posted February 3, 2017 Share Posted February 3, 2017 NewGen FAQ Sticky. 2nd page under my name. Link to FSMand procedures. O. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.