Tcdaddy Posted March 14, 2017 Share Posted March 14, 2017 Hello all, I have a 1990 Legacy LS. This morning my motorized mice died, unfortunately in the down position. Now I have no shoulder belt. Also I noticed the IP warning beep for the belts and doors isn't sounding. Anyone have any ideas? Quote Link to comment Share on other sites More sharing options...
Tcdaddy Posted March 15, 2017 Author Share Posted March 15, 2017 (edited) There is a pocket at the front edge of the rear seat , down by the floor, that has an allen wrench in it that is for cranking the belts back. Each B-pilar has an acess hole at the bottom for cranking the belts back. If you pull the trim panel off of the b-pillar, you can unplug the belts motor. Then just use the "emergeny" release button and pretend you're hooking up a 2 point harness each time you get in. Found this post from 2007 by going back to google and typing in 1990 Subaru automatic seat belts. When I tried the same search on the message board, I got nuthin'. Don't the archives go back that far? Anyway I did both cranking and unplugging and now I have 2-step manual seat belts, and I'm ok with that. Took about 10-15 minutes and I'm happy. Always hated those "mice" belts. Edited March 15, 2017 by Tcdaddy Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.