Groucho Posted May 6, 2017 Share Posted May 6, 2017 I just hooked up a 87 GL wagon with a SJR lift and some other mods, but little info about them (and of course no papers..). I'm trying to determine which lift is on the car - can I assume it's a 3" lift if all of the lift hardware measures 3"? I was also told I would need to replace the struts eventually - tho it's running fine on stock struts now. Any suggestions on the best setup? Thanks for any info - I'm new to the Subaru world. In fact, this is the first car I've owned since the 90's. Quote Link to comment Share on other sites More sharing options...
ferp420 Posted May 6, 2017 Share Posted May 6, 2017 (edited) Sounds like alot of fun enjoy Edited May 6, 2017 by ferp420 1 Quote Link to comment Share on other sites More sharing options...
Scott in Bellingham Posted May 8, 2017 Share Posted May 8, 2017 On a SJR 4" lift all the lower blocks are 3" 2 Quote Link to comment Share on other sites More sharing options...
Groucho Posted May 21, 2017 Author Share Posted May 21, 2017 Yeah so fun! I'm living up around Grass Valley & it's basically endless fire roads.. 1 Quote Link to comment Share on other sites More sharing options...
Groucho Posted May 21, 2017 Author Share Posted May 21, 2017 (edited) On a SJR 4" lift all the lower blocks are 3" Thanks that's the info I needed! I saw u post somewhere else that u run the factory struts with your lifts - u think that's the best set up? Only wondering because the mechanic I bought the wagon from said I would need to replace the struts ... Edited May 21, 2017 by Groucho Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.