Jump to content
Ultimate Subaru Message Board

95 Legacy No spark after head gasket replacement, Help!?


Recommended Posts

Hello all,

we recently went through our 95 Subaru legacy 2.2L, redid the head gaskets and replaced several other seals, got it all put back together and now we have no spark. we checked the coil pack, Crank sensor, Ignitor, Fuses, Cam sensor, Timing (4 times..), and still nothing. but we dont have a code reader and would like to check the ECM, before going all the way through the wiring. any help would be greatly appreciated, we are at our wits end here.

 

Thanks in advance!

Link to comment
Share on other sites

Well, many thanks to all of you! We finally discovered what we did wrong... This is going to sound funny I hope, as I am still laughing at myself for it. We installed the Cam pullys wrong. The right one is on Drivers side.... I can chalk it up to a loooong day... we read on this site that the number 1 thing was that we did something in the wrong order or put something in the wrong spot....  we of course only realized our mistake after going through ALL the wiring, but hey. I really appreciate this site and all of your help. we will be swapping the Pully's to the right position tomorrow morning. Thanks again!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...