Jump to content
Ultimate Subaru Message Board

Alternator wiring?


 Share

Recommended Posts

Got new connector on alternator. Battery tested good, alternator tested good. Still showing 8 volts on gauges and reading 8.6 on dvom. this tells me my alternator is bad. Replaced alternator and still same story. Could i have a bad ground or not enough ground? My Impreza with alloy block need like 8 to function so maybe? On the alternator there is a stud that has a "e" next to it, does this mean a ground? Also I guess I am missing more ground straps than I thought after searching.Does anybody have knowledge of where grounds need to be? Please and thanks in advance.

Link to comment
Share on other sites

There should be a heavy ground wire [about the size of the one to the starter +]  from the bell housing bolt shared by the starter to the battery (-).  There should be another, about AWG10 from the battery (-) to the car body.  Usually, the alternator ground happens through it's mounting bolts. 

 

Voltmeter - one lead on the alternator case, the other on the battery (-) while running, you should not see much voltage.  With everything off, you should see close to zero ohms.

Link to comment
Share on other sites

Got main negative battery cable from bellhousing to battery. One similar size going to the strut tower, or should it be like a steel part like the subframe? Didn't think of it before, the fusible links being bad could mess up my day too some I'm going to put he new square ones in like a just read in another post. It just won't charge and battery and alternator is brand new. My Impreza did the same and found out it was bad grounding.

Link to comment
Share on other sites

It could be jumping around for a lot of reasons.

Loose or poor connection anywhere in the charging circuit could do that.

That includes circuitry inside the alternator, the car system, and the battery. More tests are needed to pin it down to 1 part. Battery cranKS the car ok, runs headlights ok, so battery probably ok.

Dyplicate the situation when the meter jumps around, put the parking lights on, what does it do then? Add the headlights, what then?

Link to comment
Share on other sites

I decided to fall in and buy a new alternator. Before with old alternator, brake fluid, charge light would not come on with the key in on or starting. Car would fire up, but reading only 9v while running. Now I have those lights so I got a little further. I believe I am going to have to rip the loom of and do a wiring job with new wire. The old wire is brittle and it's the only thing that makes sense to me now.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...