Jump to content
Ultimate Subaru Message Board

Idle Air Control reset, how?


Recommended Posts

Since -by accident- I closed the air-inlet of the carburettor, the engine  runs rough when idle. Only 2 cil work.

When I follow different instructions from YT how to reset the IACV it does not work properly. The engine runs then -after warming up- 1200, 2000, 1200, 2000 etc rpm. I drove some km's to re-learn the chip. Alas no effect. 

The garage could not get an error-code, it all seemed to be okay... no way.

Someone advice?

Edited by Wivoorst
Link to comment
Share on other sites

  • 2 weeks later...

Sorry for the long waiting!

IACV of My Forester was repaired by me. It was só dirty that it couldn't work anymore! It was hard to find the reason, also 'cause it's an OBD1. Here in Holland it's quite rare.

Now I have more probs it seems. This afternoon a Subaru-dealer will check the ECU. Subaru is not very common and so there are not only-Subaru dealers. But Bosch-garages should be able to read. I can't wait till this afternoon.

Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...