MikeinTenn Posted September 23, 2004 Share Posted September 23, 2004 I have a 97 impreza 2.2, my blower only works on high. I have checked the switch which is working fine and replaced the relay in the &%$@#$ spot under the dash, still no luck. when i turn the switch from off to 1, i can hear the click of the relay, but no fan. When the switch reaches the #4 position, the blower comes high. Any thoughts? Quote Link to comment Share on other sites More sharing options...
sea#3 Posted September 23, 2004 Share Posted September 23, 2004 Mikeintenn Your drop resistor has popped the breaker that is inside your drop resistor ( it has desoldered it's self) It is located in the heater housing behind the glove box ( white 4 terminal connector) pull it out and carefully pry between the white plastic peice that the connector plugs into and the partical board that is attached to the square cage . Once you have the white plastic peice off , straighten out the tabs that are bent over , pry the partical board off the cage . The resistor will come with the partical board , there should be a peice of solder floating around in the cage . You should see a loop on the resistor that is the breaker it should be lifted off of where it should be soldered. Just solder it back on NOTE: if it pops again you may have a problem with you blower motor drawing to much current SEA#3 Quote Link to comment Share on other sites More sharing options...
djmark7 Posted September 23, 2004 Share Posted September 23, 2004 boy i wish you posted this a month ago, i woulda saved $50.00 lol Mark Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.