FATSIORIS Posted September 24, 2004 Share Posted September 24, 2004 Subaru Mini Jumbo M80 1991 Is It Necessary To Remove Engine For Clutch Replacement? Quote Link to comment Share on other sites More sharing options...
edrach Posted September 24, 2004 Share Posted September 24, 2004 If you have an engine hoist, it's generally easier to remove/re-install the engine when doing a clutch job. There's less work involved in removing the transmission, but it's more difficult to re-install the transmission after the clutch work than re-installing an engine. Subaru Mini Jumbo M80 1991 Is It Necessary To Remove Engine For Clutch Replacement? Quote Link to comment Share on other sites More sharing options...
archemitis Posted September 24, 2004 Share Posted September 24, 2004 i think the subaru motor is the easiest motor in the world, to remove, and install. it weighs about 200 lbs, and faces forward, so with the radiator out, theres tons of room. i say do the engine pull. but... my cousin did do it in about 6 hours by pulling the tranny back only about 8 inches, and leaving the cvs installed. lining up the clutch with the alighment tool was tough tho, and he had to spin the flywheel to move each bolt to the bottom of the wheel, one by one. i like pullin motors =] Quote Link to comment Share on other sites More sharing options...
CIS Subaru Posted September 26, 2004 Share Posted September 26, 2004 Uh, guys... You seem to have totally ignored what type of Subaru he has. This isn't his, but probably similar... http://www.digipix.org/mini-jumbo Looks like maybe it's a Justy motor? It's small, inline, and transverse anyways. Quote Link to comment Share on other sites More sharing options...
MilesFox Posted September 28, 2004 Share Posted September 28, 2004 what is it some kind of justy minivan? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.