falling Posted August 18, 2003 Share Posted August 18, 2003 My 92 Legacy came equipped with the ride height controls. but it has been converted to regular suspension by the previous owner. My question is how do I get the ride height light to stay off? It now occcasionally comes on and will flash until I turn off the car. I have pulled the fuse for the ride height out of the fuse block, but that didn't get it. Any suggestions? Thanks again. Quote Link to comment Share on other sites More sharing options...
calebz Posted August 18, 2003 Share Posted August 18, 2003 My 87 turbowagon does that too(used to have the ride height suspension.. been converted). still haven't figured out how to get rid of it. that flashy light is irritating. Quote Link to comment Share on other sites More sharing options...
falling Posted August 18, 2003 Author Share Posted August 18, 2003 It is very annoying. The previous owner had a piece of masking tape stuck over it. I would rather figure out how to get the switch out and pull the wire to it instead. Quote Link to comment Share on other sites More sharing options...
Hondasucks Posted August 18, 2003 Share Posted August 18, 2003 If it is the switch in the dash that flashes, just pry the switch out with a small flat blade screw driver and unplug it. You can go to a junk yard and get the plastic plug out of any Legacy 90-94 that does not have height control, then you can just remove the switch entirely. Quote Link to comment Share on other sites More sharing options...
falling Posted August 18, 2003 Author Share Posted August 18, 2003 Ok small screwdriver it is, was wondering if it would be that simple. Thanks ! Quote Link to comment Share on other sites More sharing options...
Legacy777 Posted August 18, 2003 Share Posted August 18, 2003 have you tried to pull the fuse for the height control. Quote Link to comment Share on other sites More sharing options...
falling Posted August 19, 2003 Author Share Posted August 19, 2003 I did pull the fuse from the block, thought that would fix it, but it didn't. But I have now utilized the small screwdriver and disconnected the switch from the wiring harness. I put the switch back in to the original hole, without being conected, just so it looks pretty. Quote Link to comment Share on other sites More sharing options...
Hocrest Posted August 19, 2003 Share Posted August 19, 2003 On the side of the switch are two round plugs. They can be 1/4 turned out. They are two spare light bulbs now, if you need them for another switch or panel on your dash. All of the soobs I've had (85-97) use that same type of base on the dash bulbs. Some of the bulbs are different lengths and colors though. Quote Link to comment Share on other sites More sharing options...
falling Posted August 19, 2003 Author Share Posted August 19, 2003 Excellent Information, Thanks Dave. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.