Jump to content
Ultimate Subaru Message Board

Recommended Posts

Hello, I had posted this in Older Generation of Subarus forum. Flowmastered87GL said to try looking in this one. So here is my original post. By the way, I'm a newbie, does it show?

"my wife's 93 Subaru Impreza /w automatic trans. will not start. Full fuel tank, gear shift is in park, good battery. I get lights the whole nine yards. It's just when I turn the key, to start it I get nothing. I have noticed the power light comes on. Could that have something to do with it? If so what?. I am thinking a problem with the starter. I am at my wit's end."

 

Any help would be appreciated

Link to comment
Share on other sites

1. Check and clean battery terminals.

 

2. Have you tried jumpstarting?

 

3. Do you get a loud click from the starter when you turn the key? If so, then the solenoid contacts inside the starter are bad, as they get arced up after many starts. If not, make sure the 12 volts from the key switch is getting to the small terminal on the starter.

Link to comment
Share on other sites

1. Try jumpstart and u can try give a little kick with a hammer to your starter

2.If starter click loud try remove>open>clean>put together>install

I did the same 2 years ago and saved 70 bucks cose i have been told by mechanic to change starter....

Link to comment
Share on other sites

Thanks for the help. I owe ya one. Big time.

 

Did you get the car started yet? When you turn the key do you hear ANYTHING? If you hear nothing at all, not even a click, push you shift lever with a firm bump forward into the park position and then see what happens.

Link to comment
Share on other sites

Did you get the car started yet? When you turn the key do you hear ANYTHING? If you hear nothing at all, not even a click, push you shift lever with a firm bump forward into the park position and then see what happens.
Yes I did. It was the starter solenoid. Now here's a new wrinkle, the Check Engine light is flashing steadily. About once every second. I'm not sure, but can anyone tell me if I have to reset something and, if I do where is the reset located? . By the way, I would just like to thank everyone that helped me.
Link to comment
Share on other sites

Just undo the negative battery cable for about 15 minutes or so. That should clear it I believe.

 

 

 

Yes I did. It was the starter solenoid. Now here's a new wrinkle, the Check Engine light is flashing steadily. About once every second. I'm not sure, but can anyone tell me if I have to reset something and, if I do where is the reset located? . By the way, I would just like to thank everyone that helped me.
Link to comment
Share on other sites

I think if it is constantly flashing every second you have to disconnect the black connectors underneath the dash that are used to retrieve the codes. It simply means "all clear". Check out Legacy777 website if you don't already know about retrieval of codes etc.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...