98legacywv Posted April 29, 2005 Share Posted April 29, 2005 My car is now making a wierd rattling noise where the clutch cylinder pushes the rod against the tongue (for lack of better word) that comes out of the transmission. Since the car is a hydraulic clutch is it just and adjustment? or am i headed for more problems.. as if i havent had enough with this car already.. Quote Link to comment Share on other sites More sharing options...
Gnuman Posted April 29, 2005 Share Posted April 29, 2005 My car is now making a wierd rattling noise where the clutch cylinder pushes the rod against the tongue (for lack of better word) that comes out of the transmission. Since the car is a hydraulic clutch is it just and adjustment? or am i headed for more problems.. as if i havent had enough with this car already.. fork is a better word. . . that "tounge" is the clutch release fork, and really should not be rattling. Is there a good level of fluid in the resivior? has the cluch been slipping at all? Is there residue from a possable fluid leak in the area? Quote Link to comment Share on other sites More sharing options...
MDW25gt Posted April 30, 2005 Share Posted April 30, 2005 My car is now making a wierd rattling noise where the clutch cylinder pushes the rod against the tongue (for lack of better word) that comes out of the transmission. Since the car is a hydraulic clutch is it just and adjustment? or am i headed for more problems.. as if i havent had enough with this car already.. I had the same problem. turned out it was the slave cylinder. easy to change and costs about $75. (2) bolts and the hose, then bleed the system. Seems the spring gets lazy or the cylinder bore gets fouled. this inhibits the piston from maintaining contact with the fork. Quote Link to comment Share on other sites More sharing options...
98legacywv Posted May 2, 2005 Author Share Posted May 2, 2005 there are no signs of leaking.. my clutch doesnt slip but you dont have to push very far on the pedal before it does... i think it worn but not worn out.. i figured it was a problem with the slave cylinder or the fork itself because the rubber or plastic grommet around the fork entrance to the tranny is kinda of old and in bad shape. Quote Link to comment Share on other sites More sharing options...
Scottbaru Posted May 2, 2005 Share Posted May 2, 2005 <snip>the rubber or plastic grommet around the fork entrance to the tranny is kinda of old and in bad shape.Mine too, I've asked before if there's a source for new ones. I fear if I leave that hole open, salty road slush will find it's way in there. Quote Link to comment Share on other sites More sharing options...
Al_SemC Posted May 2, 2005 Share Posted May 2, 2005 Check the play between the fork and the slave piston. It should be 1/8"-5/32", according to my book here. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.