Jump to content
Ultimate Subaru Message Board

hard starting and engine code problems


Recommended Posts

i am experiencing intermittent hard starting problems. they only occur once or less a week, when car is fully warmed up. engine turns over, but fails to start. eventually i can get it started by pumping gas vigorously. check engine light then comes on with camshaft position sensor error code. have had local garage turn off light, but a week later it happens again. 96 impreza 2.2. anyone have ideas? thanx

Link to comment
Share on other sites

If you get a camshaft position sensor code and you turn off the «light», it's like killing the messenger...:brolleye:

Just replace it, it's a five minute repair, one connector and one bolt. The sensor in on the left (driver) front side of the engne not far from the oil dip stick.

17$ at 1stSubaruparts

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...