DaveAP Posted November 1, 2003 Share Posted November 1, 2003 I just stripped out an 16 and 1800 motor, and broke both the oil pumps taking them off. Both broke at the base. What am I doing to these poor pumps? Quote Link to comment Share on other sites More sharing options...
PHATBRAT Posted November 1, 2003 Share Posted November 1, 2003 Can't say it's you if you are pulling them off. After you pull everything off, tap them gently with a rubber mallet to loosen them. If you are taking them off to replace them then who cares. If you are replacing a seal then take your time and tap them like I said. Quote Link to comment Share on other sites More sharing options...
MilesFox Posted November 1, 2003 Share Posted November 1, 2003 there will be a small bolt off to one side if you are over looking it. there should be 5 bolts! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.