Jump to content
Ultimate Subaru Message Board

EA 82 Turbo to regular Fuel injected engine


Recommended Posts

I have a 1988 GL-10 that was orginally a turbo car,I put a regular SPFI engine in itI have the wire harness and ECU from that engineThe old wire harness that is in the car just does not match up to the turbo harness,Will I have to pull the old turbo harness and install the SPFI harness and ECU?If so How is it routed?and the best way of Pulling the old harness and installing the right harness for this engine?Thank You Very Much in advance!

Link to comment
Share on other sites

Was the turbo SPFI or MPFI? If it was SPFI, it should be possible to use the same turbo harness along with some parts off the turbo engine -- just swap the long block and forget the up pipe and turbo -- it will just think it has zero boost all the time now. If the turbo was MPFI though (the EA82 turbo's were MPFI, right???), the new engine won't have the right heads though....

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...