Jump to content
Ultimate Subaru Message Board

Old Gen.: 80's GL/DL/XT/Loyales...

If your Subaru was built after 1980 but before 1990 or is a Loyale, Justy, XT or XT6 please post here. Includes 1982 and newer Brat, GL, RX&RS. 1600/1800/2700 ea71/81/82 and ER27 engines.

47277 topics in this forum

  1. EA81 to EJ22 Swap: 1982 Subaru Brat

    By SaltyMike,
    • 1 reply
    • 409 views

  2. HELP! 89 subaru EA82 SPFI will not start. 1 2

    By Heater,
    • 30 replies
    • 1.9k views

  3. Brat axle and cv questions

    By BratshitCrazy,
    • 2 replies
    • 432 views

  4. powered cover fog lights off JDM EA82 - hitting big time values yet?

    By Steptoe's photos,
    • 7 replies
    • 519 views

  5. 1980 Brat Tire Size

    By Otterby,
    • 3 replies
    • 692 views

  6. 1985 EA82T thermostat housing idle air control housing

    By gbacon67,
    • 3 replies
    • 681 views

  7. Throwout bearing springs

    By Espey16,
    • 7 replies
    • 651 views

  8. 1988 Justy 1.2L showing low compression on cylinders 1 and 3.

    By darsdoug,
    • 13 replies
    • 735 views

  9. Oil pump detent

    By Espey16,
    • 9 replies
    • 573 views

  10. Low interior voltage meter reading

    By Geluso,
    • 8 replies
    • 917 views

  11. 1992 Subaru Loyale wagon 4WD won’t start

    By J41YD3D.,
    • 6 replies
    • 739 views

  12. Got a sunroof?

    By scoobydube,
    • 2 replies
    • 493 views

  13. source for EA82T Hitachi Distributors or Ignition modules ?

    By photorich65,
    • 10 replies
    • 743 views

  14. 1983 moss green GL in excellent condition. Do I bring her back to life or part it out for the running GL's out there?

    By glALABAMA83,   
    • 4 replies
    • 473 views

  15. i need a throttle position sensor for my 1991 subaru Loyale

    By Wyatt3.14,   
    • 2 replies
    • 344 views

  16. New lifters/hla's

    By Espey16,
    • 13 replies
    • 506 views

  17. EA81: help to identify gaskets in full set

    By torpedo51,
    • 1 reply
    • 341 views

  18. 83 GL Carter Weber carb help

    By glALABAMA83,   
    • 12 replies
    • 1.1k views

  19. EA81: need oversized pistons .020

    By torpedo51,
    • 5 replies
    • 580 views

  20. EA81 - help to identify year, make, model

    By torpedo51,
    • 9 replies
    • 825 views

  21. EA81 - need picture of timing cover please

    By torpedo51,
    • 7 replies
    • 640 views

  22. EA81: oil control piston rings alignment

    By torpedo51,
    • 9 replies
    • 1k views

  23. EA81 - mounting boss broken off of cylinder head - two heads are identical?

    By torpedo51,
    • 3 replies
    • 434 views

  24. Anyone with a totalled or scrap brat ??

    By Crawlerdan,
    • 5 replies
    • 966 views

  25. Doing the Gen2 alternator upgrade, need v pulley, what should I do?

    By mkoch,   
    • 1 reply
    • 404 views
×
×
  • Create New...