nerpel

Ya that's right those are 31" tires and no they don't rub.

I was not planning on swapping the auto trans as well i just stated they the ej 2.2 came from an automatic impreza. So that being said it's still a no go?

Please can someone tell me for sure if i can swap a ej2.2 sohc engine from a 96 automatic impreza into my m/t 04 Forester with a ej2.5 sohc engine? Yes i do have the full wire harness and ecu from the impreza as well. Please let me know ASAP thanks in advance.

Yes i am! Than. You to everyone who likes!

Hello there to every one out there talking about my lift. I was only building a six inch lift to begin with. And yes einstien it is considered a ten and a half inch lift when you build 6.5 inch spacers for the top of your 2001 forester struts with kyb gr2S . On iT. And this is my third subaru i have built. Fully on my own without anykind of instructions. All my cars have all driven good.

So i have an 06 outback. The other day while driving the engine light came on and the cruise started flashing. So i ran the codes and got bank one number one oxy sensor. So i replaced it. With only a lil change but not much. So my question is! Can i hollow out my cats?

Sweet nice to know once i figure out how to load my pics i will. Oh and its 4eat auto right now and i like it. What can i do with it wheelung wise and power placement?

I have a 96 legacy wagon that i just finished lifting. I was building a six inch lift but a week into it i noticed that i over built. I now have 30/9 .5 by15 on it with no rubbing

I have a 96 legacy wagon that i just finished lifting. I was building a six inch lift but a week into it i noticed that i over built. I now have 30/9 .5 by15 on it with no rubbing. How do i load pics from my phone? Uuuuhhhggg.

I have a 96 legacy wagon that i just finished lifting. I was building a six inch lift but a week into it i noticed that i over built. I now have 30/9 .5 by15 on it with no rubbing

I lifted my 97 legacy last week . Well the last two weeks actually. But now i really want the high and low five speed. What do i need to do. I have the tranny and hooking it all up is pretty much strait forward but what about the bfll housing