Jump to content
Ultimate Subaru Message Board

Search the Community

Showing results for tags '1999 Outback'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Welcome to the USMB!
    • Meet n' Greet. Your USMB Welcome Center
    • Members Rides
  • Older Generations of Subaru's 1960-1994 Except Legacy and Impreza
    • Historic Subaru Forum: 50's thru 70's
    • Old Gen.: 80's GL/DL/XT/Loyales...
  • Newer Generations of Subaru discussion
    • 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX
    • BRZ and its Sister the Scion FRS/Toyota GT86
    • Crosstrek "XV"
  • Marketplace
    • Ultimate Subaru Store
    • Products for your Subaru
  • Upgrading and Racing Discussion
    • Performance Tech Forums
    • Subaru Modifications
    • Subaru MotorSports
  • Ultimate Subaru Repair Manual-The Knowledge Base of USMB. Complied posts and writeups to common problems and projects.
    • Submit a Tip or Mod to the USRM
    • Product Links and References
    • The old Ultimate Subaru Repair Manual
    • Engine
    • Engine Electrical
    • Transmission, Axle, and Brakes
    • Heating and Cooling systems
    • Body Exterior
    • Interior / Body Electrical
    • Stereo tips and tricks
    • Offroad Modifications
    • Suspension and Steering
  • Off Topic Areas
    • Shop Talk
    • Alternative Vehicles (non soob)

Product Groups

  • Member Accounts
  • Ultimate Subaru Decals
  • Subaru Parts
    • Weber Carbs and Parts
    • Used Subaru Parts

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Full Real Name


Occupation


Ezboard Name


Referral


Biography


Vehicles

Found 1 result

  1. I have a '99 Outback with about 186k that I bought for the kids. My daughter complained about it running rougher than usual at idle. I picked it up from her school and she was right! It tripped P0301 and P0303 codes (misfire on 1 & 3). I was able to limp home with it. Here's what I have done so far: 1. Changed plugs and wires 2. Changed Coil and Air Cleaner After doing this, I tried the car. It kept stalling (see detailed description below). I was able (barely by giving it lots of gas) to get it the 20 feet into my garage so I could work on it out of the rain, but that's about it). 3. Changed timing belt, hydraulic tensioner and all idlers (see below, they were past their expiration date) 4. Changed water pump (well, I figured since I was in there anyway...) 5. Changed upper and lower radiator hoses and thermostat (again, since I was there..) 6. Changed alternator/PS belt and AC compressor belt, as well as idler on the AC belt tensioner (after all, my kids are driving it...) So, here's where the story gets interesting. When I opened the timing belt cover, I found a rubber-covered metal ring floating around in the sprockets. It ends up it is the ball-bearing cover on the idler wheel that has the teeth (don't know the technical term for this). So, clearly that idler was fubar and it's a fair assumption that this foreign body probably caused the timing belt to skip, resulting in the misfires. I put the car together and started it up. It started right away, sounded smooth, revved up to about 1500 RPM, and then died. Thinking that maybe the computer needed to relearn the idle, I disconnected the battery for a minute or so and then turned the ignition on for a minute or so, and then started it up. Some thing. No CEL and no codes came up, but it just doesn't run. If I give the car lots of gas, I can keep it running, but it tries to die every few seconds and I need to pump the throttle to keep it running. Don't think that I can move it like this, since every time I try to shift it into gear, it will stall. Suggestions are welcome! Thank you.
×
×
  • Create New...