Jump to content
Ultimate Subaru Message Board

Search the Community

Showing results for tags 'antifreeze'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Welcome to the USMB!
    • Meet n' Greet. Your USMB Welcome Center
    • Members Rides
  • Older Generations of Subaru's 1960-1994 Except Legacy and Impreza
    • Historic Subaru Forum: 50's thru 70's
    • Old Gen.: 80's GL/DL/XT/Loyales...
  • Newer Generations of Subaru discussion
    • 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX
    • BRZ and its Sister the Scion FRS/Toyota GT86
    • Crosstrek "XV"
  • Marketplace
    • Ultimate Subaru Store
    • Products for your Subaru
  • Upgrading and Racing Discussion
    • Performance Tech Forums
    • Subaru Modifications
    • Subaru MotorSports
  • Ultimate Subaru Repair Manual-The Knowledge Base of USMB. Complied posts and writeups to common problems and projects.
    • Submit a Tip or Mod to the USRM
    • Product Links and References
    • The old Ultimate Subaru Repair Manual
    • Engine
    • Engine Electrical
    • Transmission, Axle, and Brakes
    • Heating and Cooling systems
    • Body Exterior
    • Interior / Body Electrical
    • Stereo tips and tricks
    • Offroad Modifications
    • Suspension and Steering
  • Off Topic Areas
    • Shop Talk
    • Alternative Vehicles (non soob)

Product Groups

  • Member Accounts
  • Ultimate Subaru Decals
  • Subaru Parts
    • Weber Carbs and Parts
    • Used Subaru Parts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Full Real Name


Ezboard Name




Found 3 results

  1. questions: is this what I think it is, and how important is it? thanks to all who helped me with the last issues, now I found the real culprit as to where coolant was leaking. apparently the little plastic piece is called a Termocontrol valve assembly (described it to a shop and that's the answer I got). it is a little plastic elbow with some kind of valve in it, has ~13mm bolt on the end of it. not sure how one would turn the bolt, as the plastic it is threaded into is crap. it might be heat activated. the valve is connecting on both ends by 1/4"ID hose. location of this piece: from the water pump, there is a rubber elbow hose about 6" long that connects to a metal T under the air filter (not in it), and behind the alternator. the top of the T connects to heater hose that goes through the firewall. the stick part of the T has a 1"piece of what looks like 1/4"ID hose connecting to the plastic piece I described above. following that plastic elbow, the next piece of hose connects to the base of the hitachi carb. so, I am in there, now I don't exactly know where to go from here. my instinct tells me to skip it and just leave it out of the picture. my instinct also tells me I am an idiot and will probably screw something up and should as a professional. thanks again USMB
  2. Okay, so about two weeks I swapped my EA82's longblock. It came with a brand new water pump. The first day, I noticed some coolant loss, but it was a combination of bleeding the system, letting coolant pump through every hose, and I didn't fill up the overflow tank. By the second day, she was holding coolant nicely. About a week later, I notice the temp gauge is reading a bit higher than normal (not overheating though). Up until then, I noticed no coolant loss, and I was checking it every day. However, the radiator went dry and there was no coolant in the overflow tank. I noticed no visible leaks. Filled her up and wanted to double check the coolant to make sure. Wasn't noticing any problems, until I turned the car off when I got to work today. As always, I look back at my car when I walk away, haha. But this time, I noticed coolant was dripping pretty fast out the bottom of the car. I crawl underneath, and find it's dripping from the oil pan onto the skidplate onto the ground. Pop the hood, and notice no visible leaks. Completely dry of coolant, but yet it's still dripping out onto the ground. I had to clock on, so I left the car sitting. Nine hours later, I need to get home. First thing I did was adjust the metal pipe that fits in between the driver side radiator hose and the water pump. Adjusted it so it sits better on the water pump. I start adding some coolant, and it starts dripping out the bottom again. Again, no visible leaks. Luckily, I only live 5 minutes from work, so I was able to drive it home. Got home right as the temp gauge reached its normal readings, so it didn't overheat. Turned the car off, and noticed smoke coming out of the grill. Pop the hood and find coolant sprayed around the water pump. At this point, it is NOT dripping coolant on the ground. So anyways, anyone have tips? I searched topics on water pumps, but there aren't many threads about it. Best solution I could find is that new water pumps will do this, especially if there's debris in the cooling system, and it'll eventually fix itself. I can do some work in the morning, but should I just run the car a bit more and see if it fixes it? Oh, I forgot to mention that I've noticed no other problems. No overheating, no coolant in the oil, no oil in the coolant, etc. Here is video of it dripping out, and what happened when I got home: http://www.youtube.com/watch?v=fs_l8KwI0I4&list=PLWKW712Na2Z5uYMhUIrlkcgGSaNQ8ozGA&index=1 Thanks for any help! 1990 Subaru Loyale, EA82 (swapped exactly 400 miles ago, has 116K on the motor, new water pump, longblock)
  3. Hello, I need help to determine the problem with my 2006 outback xt. I recently started seeing a leak under the car, antifreeze smell and windows fogging, reading some the blogs it seems like I have a heater core problem, if you agree with what do you think it costs to fix this issue?? Thanks for your help....
  • Create New...