Jump to content
Ultimate Subaru Message Board

Search the Community

Showing results for tags 'ea82m'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Welcome to the USMB!
    • Meet n' Greet. Your USMB Welcome Center
    • Members Rides
  • Older Generations of Subaru's 1960-1994 Except Legacy and Impreza
    • Historic Subaru Forum: 50's thru 70's
    • Old Gen.: 80's GL/DL/XT/Loyales...
  • Newer Generations of Subaru discussion
    • 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX
    • BRZ and its Sister the Scion FRS/Toyota GT86
    • Crosstrek "XV"
  • Marketplace
    • Ultimate Subaru Store
    • Products for your Subaru
  • Upgrading and Racing Discussion
    • Performance Tech Forums
    • Subaru Modifications
    • Subaru MotorSports
  • Ultimate Subaru Repair Manual-The Knowledge Base of USMB. Complied posts and writeups to common problems and projects.
    • Submit a Tip or Mod to the USRM
    • Product Links and References
    • The old Ultimate Subaru Repair Manual
    • Engine
    • Engine Electrical
    • Transmission, Axle, and Brakes
    • Heating and Cooling systems
    • Body Exterior
    • Interior / Body Electrical
    • Stereo tips and tricks
    • Offroad Modifications
    • Suspension and Steering
  • Off Topic Areas
    • Shop Talk
    • Alternative Vehicles (non soob)

Product Groups

  • Member Accounts
  • Ultimate Subaru Decals
  • Subaru Parts
    • Weber Carbs and Parts
    • Used Subaru Parts

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Full Real Name


Occupation


Ezboard Name


Referral


Biography


Vehicles

Found 1 result

  1. Hey everyone, My 87 'Rally Wagon' had recently started showing signs of HG failure (frothy coolant & coolant loss) so I pulled the engine and found that it was just my heads that were toast... so, I've decided to keep my low compression block (7.7:1) for a spare and I'm putting the old heads onto an XT block for fun(: the XT engine-(MPFI 9.5:1 comp) What I want to know about this is if there's anything other than the obvious dangers of running boost with high compression.. if anybody has built one of these and run it dependably for any amount of time, what did you do? What should I look out for? And what's the most common failure point of these? This is my test engine, and if I like it I'm going to build a fresh block, ported heads, ported turbo, and eventually a propane set-up Thanks everyone for any input, I'm not expecting anything more than a mass amout of power and eventually a big bang over time with this one haha(: but id like to delay the bang until I get it all running right
×
×
  • Create New...