Jump to content
Ultimate Subaru Message Board

Search the Community

Showing results for tags 'plate'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Welcome to the USMB!
    • Meet n' Greet. Your USMB Welcome Center
    • Members Rides
  • Older Generations of Subaru's 1960-1994 Except Legacy and Impreza
    • Historic Subaru Forum: 50's thru 70's
    • Old Gen.: 80's GL/DL/XT/Loyales...
  • Newer Generations of Subaru discussion
    • 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX
    • BRZ and its Sister the Scion FRS/Toyota GT86
    • Crosstrek "XV"
  • Marketplace
    • Ultimate Subaru Store
    • Products for your Subaru
  • Upgrading and Racing Discussion
    • Performance Tech Forums
    • Subaru Modifications
    • Subaru MotorSports
  • Ultimate Subaru Repair Manual-The Knowledge Base of USMB. Complied posts and writeups to common problems and projects.
    • Submit a Tip or Mod to the USRM
    • Product Links and References
    • The old Ultimate Subaru Repair Manual
    • Engine
    • Engine Electrical
    • Transmission, Axle, and Brakes
    • Heating and Cooling systems
    • Body Exterior
    • Interior / Body Electrical
    • Stereo tips and tricks
    • Offroad Modifications
    • Suspension and Steering
  • Off Topic Areas
    • Shop Talk
    • Alternative Vehicles (non soob)

Product Groups

  • Member Accounts
  • Ultimate Subaru Decals
  • Subaru Parts
    • Weber Carbs and Parts
    • Used Subaru Parts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Full Real Name


Ezboard Name




Found 3 results

  1. Here is a video: The new and old clutch plates do not look the same. Will this be a problem? mkoch
  2. I have disconnected all the stuff from the engine needed to pull it. I'm going to pull it tomorrow. I will replace the clutch, and the rear oil seal. Is there any other easy convenient thing I should do while the engine is out?
  3. I may need to replace my clutch plate soon. The clutch would disengage barely enough with the clutch pedal to the floor. I adjusted the clutch cable so it is now possible to press the clutch pedal to he floor put the transmission into reverse without hearing the clashing of gears, but... accelerating with the clutch fully engaged, it looks like the clutch slips. The RPM rise at full throttle without the expected corresponding acceleration. I last did this job on a Gen 2 Subaru in 1989! I think I can do it again. Please, I would like advice on... Where to buy parts, including the insert to position the clutch plate What other jobs should I do on the engine, as it will be out of the car, and easy to work on? mkoch
  • Create New...