Search the Community
Showing results for tags 'second'.
Found 12 results
-
I stripped a hun on my 1985 BRAT, for the second time! The 36mm castellated nut was at the right torque, with cotter pin. What am I doing wrong?
-
85 BRAT, where is AC thermostat? I want to locate every component. Pic
-
I want to replace the heater hose on my '85 BRAT. What diameter should I get?
-
I had what seemed like front axle problems. I can drive in 4wd, but not 2wd. The video explains is all. Parking brake on, engine running, 1st gear 2wd , clutch engaged. The castellated nut just spins! https://youtube.com/shorts/yYehV4mw_lg?feature=share What th... What's the problem??
-
The video tells the story!!! The left turn signal switch will activate flashing in bulbs other than the turn signal bulb! https://youtube.com/shorts/AtWGv5Lt3ns?feature=share
-
,85 BRAT, Hitachi, 49 state, new fuel filters, old loud fuel pump, new front and rear fuel filters. The car will hesitate and lurch under certain conditions. If I let the car just idle still for a while, and then accelerate, there is not problem accelerating, until about 20 seconds into it, then the balking begins. The normal acceleration indicates to me that both carb barrels are working. I just drove this car up a 1/10 mile 7% incline several times. I let this car idle, still, at the bottom of the hill every time before I did the test. 2nd gear, 2,000 rpm, the car makes it up the hill just fine. 2nd gear, 2,500rpm, the car starts balking halfway up the hill. I am guessing the problem is the fuel pump, or the valve which fills the float bowl. Am I missing something?
-
Heya, 1985 Brat 49 State, Hitachi carb. I replaced the Y pipe, which looked original (it had the air heater). It did not have an oxygen sensor. The replacement has one, and I wonder where in the wiring harness it connects.
-
A video where I ask the question: Is this ok? Slop at rear axle, drum removed The bearing can slide in and out with very little pressure.
-
My 85 Brat started and ran a month ago, then it sat for a month. I tried to start it, the engine would maybe 1/2 turn over with each try. Things I did Replace battery with a proven strong one. Clean battery terminals, and cable clamps, clean engine ground connection, clean positive cable connection at starter. I can swap parts with my healthy 1984 GL! What should my next step be?
-
I just bought a 1985 Brat!! I am pretty sure the parts are the same as my ‘84 GL Wagon. I need to replace the windshield. It is the same as a GL, 1984, right? I am in St. louis, and the closest windshield I can find is in Chicago. Group mind, do you have any suggestions? mkoch
-
1984 Subaru, I want to be able to tow this one. Should I connect the tow bar to the tie down points, (safe, secure) or, to the bumper (convenient, iffy) ?
-
Can the rear alignment on a 2nd generation 4wd Subaru be adjusted by mere mortals?
