Txakura Posted October 20, 2010 Share Posted October 20, 2010 Pulled wiring for a swap harness, any reason I need to keep the SMJ connector and follow it aft? Quote Link to comment Share on other sites More sharing options...
NoahDL88 Posted October 20, 2010 Share Posted October 20, 2010 Guessing its a 90-94 leggo? the SMJ has wires that are important for proper engine function on both sides of the connector. so yes, keep both sides. Quote Link to comment Share on other sites More sharing options...
Txakura Posted October 20, 2010 Author Share Posted October 20, 2010 ok. last thing to do then, all the other fun has been had guess I could have mentioned '93 Legacy, ej22E, 4eat to be more helpful ty for the quick response, I'll be back on it tomorrow Quote Link to comment Share on other sites More sharing options...
mountain brat Posted October 20, 2010 Share Posted October 20, 2010 i take the smj connector out and just solder the wires im using much cleaner and easier to install.also not that many to solder Quote Link to comment Share on other sites More sharing options...
Gloyale Posted October 20, 2010 Share Posted October 20, 2010 i take the smj connector out and just solder the wires im using much cleaner and easier to install.also not that many to solder Yeah, but he should still pull it and the rest of the harness that is attached to the Grey one. The White one is not needed, Looks like the white one in the picture is waht he was asking about. In case you haven't gotten it yet, Don't forget the wiring that runs though the firewall to the ignitor and the Crank/Cam/Knock sensors. Quote Link to comment Share on other sites More sharing options...
Txakura Posted October 20, 2010 Author Share Posted October 20, 2010 I had thought they would be spliced into the EA, tempted to dike them off at floor level - but I'll follow it to the end... can't be any worse than pulling that dash and heater core out of the way to chase everything else. I'm overdoing the pull, to have everything I could possibly need, even though I know most of it will be scrapped. A lot easier to sort on the bench after the fact... Quote Link to comment Share on other sites More sharing options...
mountain brat Posted October 21, 2010 Share Posted October 21, 2010 sorry i wasnt paying attention thought you were on the install . Quote Link to comment Share on other sites More sharing options...
Txakura Posted October 22, 2010 Author Share Posted October 22, 2010 Yeah, but he should still pull it and the rest of the harness that is attached to the Grey one. The White one is not needed, Looks like the white one in the picture is waht he was asking about. In case you haven't gotten it yet, Don't forget the wiring that runs though the firewall to the ignitor and the Crank/Cam/Knock sensors. Think I'm good on the latter, left zero wiring forward or through the fire wall, or inside the dash for that matter... only thing left was the gaggle at the driver kick panel. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.