Jump to content
Ultimate Subaru Message Board

Recommended Posts

I have a phase II 2.5 engine that I may want to get the cylinders bored .5mm oversize. Is there a fave shop that could accommodate me where I wouldn't bust the budget getting it done? I would prefer the western Washington area but the cases could do a little traveling if necessary. Thanks

Share this post


Link to post
Share on other sites

i had good luck here asking the local Subaru dealer who does their machine shop work.

Edited by grossgary

Share this post


Link to post
Share on other sites
I have a phase II 2.5 engine that I may want to get the cylinders bored .5mm oversize. Is there a fave shop that could accommodate me where I wouldn't bust the budget getting it done? I would prefer the western Washington area but the cases could do a little traveling if necessary. Thanks

 

410 Machine in Buckley.

Or contact Delta and see who they use.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×