Jump to content
Ultimate Subaru Message Board
Scott in Bellingham

Subaru engine mated to a Jeep Tranny?

Recommended Posts

that should be the A-15 ? from asian ?

 

its the same as the R 150 front housing, but I beleve the input shaft is much longer, a spacer plate would have to be built to allow the use of the current bellhousing to accept it, but it can be done

Share this post


Link to post
Share on other sites
that should be the A-15 ? from asian ?

 

its the same as the R 150 front housing, but I beleve the input shaft is much longer, a spacer plate would have to be built to allow the use of the current bellhousing to accept it, but it can be done

so a spacer may do it? I could do that , starter seems may be a issue

Share this post


Link to post
Share on other sites
so a spacer may do it? I could do that , starter seems may be a issue

 

no man, Its a direct bolt up, the only difference between the A 15 and R 150, 151, 154 is the input shaft length

 

they all share the exact same bolt pattern, thats why I included the bolt pattern on the original bellhousing, now all thats required is a spacer, or a new housing could be cast from the original pattern to include the length

Share this post


Link to post
Share on other sites
no man, Its a direct bolt up, the only difference between the A 15 and R 150, 151, 154 is the input shaft length

 

they all share the exact same bolt pattern, thats why I included the bolt pattern on the original bellhousing, now all thats required is a spacer, or a new housing could be cast from the original pattern to include the length

 

 

so your toyota adapter will work on a jeep

Share this post


Link to post
Share on other sites

its not that easy

 

 

there is a lot of attention to detail to design a functional bellhousing to a given transmission/engine combination

 

pilot bearings, throw out bearings, throw out bearing holders, custom disc's

 

everything has to work together

 

If you want to invest your time, I would be glad to help you

Share this post


Link to post
Share on other sites

I'm pretty sure the gear trains are interchangeable with those transmissions. You can use a Toyota g52 gears on the jeep ax5 main shaft. I know for sure the fifth gears swap I'm pretty sure the gears will fit the main shaft as well. I would assume that the ax15 and R series transmissions are the same way.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×