Jump to content
Ultimate Subaru Message Board
Gloyale

Mountain Mud trail competion in my Soob

Recommended Posts

I ended up reinforcing my radius rods on my 86 wagon with angle iron.  I welded it on top and bottom to where it actually makes a box around the radius rod.  Had held up a lot better than just the stock setup.  As far as the control arm bending, I never did do anything about that, I just swapped them out with other used ones.  I didnt really want to put a lot of heat to the metal since there isnt a lot there.  

Share this post


Link to post
Share on other sites

One of the radius rods I bent in these videos was already reinforced with angle iron.  It just bent hard at the very end where it meets the mounting plate.

 

This was meant to be a push it to the limits kinda run.  I ussually don't wheel quite that "balls out"

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×