torxxx Posted April 18, 2013 Share Posted April 18, 2013 I ended up reinforcing my radius rods on my 86 wagon with angle iron. I welded it on top and bottom to where it actually makes a box around the radius rod. Had held up a lot better than just the stock setup. As far as the control arm bending, I never did do anything about that, I just swapped them out with other used ones. I didnt really want to put a lot of heat to the metal since there isnt a lot there. Quote Link to comment Share on other sites More sharing options...
Gloyale Posted April 18, 2013 Author Share Posted April 18, 2013 One of the radius rods I bent in these videos was already reinforced with angle iron. It just bent hard at the very end where it meets the mounting plate. This was meant to be a push it to the limits kinda run. I ussually don't wheel quite that "balls out" Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.